How much does it run to get a set of turnout tubes for belanger headers?

[Vital Velocity]

Found a set of headers but doesnt have turnouts or gaskets....what should i expect to pay?

 

[LifeIsGood]

Call Lou Belanger - (623) 582-5900 at Belanger Headers. Jeriann might answer the phone...she runs the office and she might know.

 

[Vital Velocity]

Thanks...figured id post in case someone knew off hand

If i dont get an answer ill give them a shout in the AM

 

[DrumrBoy]

If you find out, please post the answer, I need exactly that part as well. Left a message earlier today but haven't made real-time contact as yet (still early in AZ thouugh).

 

[Vital Velocity]

$150 for the turn outs and 80 for the gaskets

 

[DrumrBoy]

Thx. I'll go place the order.

 

[Catwood]

I paid $100 per side to get them custom made adding my HF metal cats at a local muffler shop that was race friendly.

I did the side sill removal myself and drove ther with the pipe exposed. He made it the same as the pipe that came off so that I could use the old one as an Off Road Pipe.

YMMV

 

[Vital Velocity]

Yeah ill be going without the cats on mine, just need the turnout.

On a side note, does anyone know how bad this will effect the header? Seller says it has the dimple for clearance on the passanger side?

You must be registered for see images

 

[ViperTony]

Clearance from what? I'd be more worried about trueness on the flange surfaces. Depending on how they were installed overtorquing the bolts on the flange surfaces, namely the collector and Y connector flanges usually leads to leaks in those areas. Are those fresh Jet Hot coated?

 

[Vital Velocity]

This is what he said
Belanger Headers 1996-2002 Dodge Viper
Dyno tuned and track tested long tube Tri-Y Headers.
Laser cut 5/16" header plates.
Mandrel bent 1 3/4" port matched D-ported equal length primary tubes.
Primary tubes constructed of
aluminized tubing run 50% cooler than stainless steel stock exhaust.
3" collectors.
Some scratches and NOT ceramic coated