I need a power steering pulley or hub measurement

[Tomas]

Hi everyone

Yesterday I mount the hub on the power steering pump axle, I mount the hub so close as possible to the housing, but still the hub are not flush to the axle. Can someone please take a measurement for me so I know if I have the hub on right place on the axle.

thanks

rgds

Tomas

or this measurement are also interesting, from bottom of pumphousing to top of pulley

 

[Paul S Lacey]

Early bracket will do this pre 1996, had this on an RT/10 last week.

 

[Tomas]

Hi Paul

What year was the RT? This is on my 96 GTS.Some say the the hub should be flush on the axle, but in my case that is not possible??

 

[plumcrazy]

i might have a used pulley if ya need one.

 

[Paul S Lacey]

We fitted a 96 in a 94 car and with the 96 bracket the pulley was out of line. So we used the original braket and all was OK.

From memory we used the original pump and took the crate motor on off when fitted with an early pump the later bracket was fatter.

You should really email Dave at Dave'#s Big Brakes he is the master of the pulley and brackets

 

[Tomas]

Hi Paul

I emailed Dave, but he said the hub on the pulley needs to be flush(even or level) with the end of the p/s shaft. And thats is not possible.

 

[Dave's Big Brakes]

Hey Tomas,

I didn't ask, which car are you trying to install on? The billet pulley is for 96-02 with oem mounting bracket(96 RT/10 are different)

I measured the hub & pump, it's 103.76mm from the back of the pump to the front of the hub. It's about 47.3mm like in the first picture above that you have in this post.


Dave

 

[Tomas]

Hi Dave

thanks for the reply, I will mount it tonight on my -96 gts and see how its looking.

rgds

Tomas