who makes a playback boost guage

[twinvipers]

Looking for a replacement 2 1/16 inch boost guage with playback

 

[Achilles99]

Greddy and HKS do, but it'll be in BAR instead of PSI...

DEFI makes a pretty cool line of linked gauges as well.

Also, I'm not sure if the playback feature is available in 2 1/16 inch. Where are you mounting it? The next size up isn't that hard to install, with a little dremel work...

 

[Joseph Dell]

Autometer has one that doesn't do playback, but it does tell you what the peak boost was from the last time it was checked. I went with that one...

JD

 

[twinvipers]

Where did you get it JD ?

 

[Joseph Dell]

Summit racing, believe it or not!

Part # ATM-4376 .

Good luck!

JD

 

[twinvipers]

thanks JD

 

[Jack B]

Joe & Twin Vipers:

I just bought (this week)an Autometer electric fuel gauge and found out that they have converted most of their electric transducer/gauge packages to a 0-4.5 volt output. I believe any of their gauges manufactured after 5/1/04 are this way. They are trying to have all their gauges capable of feeding into their new logger.

I have an Innovative air/fuel logger that has the capability of five additional inputs. I now have air/fuel, rpm and the fuel pressure input into the logger. The new autometer electric gauges now have an output set of pins on the gauge, not the transducer. I mounted the gauge under the hood and ran the data from the gauge into my logger.

All you need is a logger. I would highly recommend the Innovative logger, or you might want to look at the Autometer setup. IMO you should start with the a/f and everything else is icing on the cake. In your case if you watch boost and not a/f it could be catastrophic

Dash mounted gauges are all show, you cannot accurately watch all the gauges and give adequate attention to driving/shifting/stopping. The air/fuel is the worst it is almost useless unless you can log. The fluctuations are too great and come too quickly to get an accurate reading with a gauge.

If you check Autometer go directly to the factory, the retail outlets don't even know about the conversion.

 

[twinvipers]

I need one that goes over 15 psi

 

[Yellow Fever]

Summit racing, believe it or not!

Part # ATM-4376 .

Good luck!

JD

Thats the one I went with !

 

[Joseph Dell]

Oh... then you want ATM-4377... that one goes to 30 psi...

Same price, though.

JD

 

[Jack B]

Why the low preessure gauges, the gauge you want is the 100 psi full sweep. The vipers are going to fun 55 psi.

 

[Achilles99]

55 psi of boost? Is it a diesel Viper ?

 

[Jack B]

Sorry - thought you were looking for a fuel pressure gauge also.