Hello,
I hope these instructions help you (please see also pics at the end)
E-Brake Bracket kit
1- Put Viper on jack stands
2-Remove rear wheels & under tray
3-Remove plastic clips that hold ABS harness to parking brake cable, both sides
4- Remove cable end and slip housing out of pulley bracket
5- Remove pulley housing from caliper. This housing and pulley will not be reused but the socket head bolts will be
6- Remove the 3 cable hold down clamps from each cable
7-Install new bracket with bracket on top side of caliper, with bolts coming up from bottom(pulley bracket was mounted on the bottom)
8- Swap cable arms side to side with arm being slightly pointing down to rear bumper, but almost horizontal
9-Caliper end of coil springs needs to be bent slightly to aim at the arm end to better grab the cable arm. The spring grabs the upper point now instead of rear point
10- Now come the hard part…. Pull the cables forward and reroute them thru the triangular opening on each side of the diff. Criss-cross on top of diff, underside of the frame rail, behind the shock, front side of the otter tie rod end, into the rectangle bracket, attach cable into slot
11- Drill new holes so clamps hold cables from moving parts
12- Plastic tie ABS harness to sway bar arms
13-When everything is done, pump parking brake handle approx 6 times to seat cable and auto-adjust parking brake mechanism
14- You can test parking brake by starting engine and work first gear against brake
15- Install undertray
16-Install wheels , torque to 90 ft lbs.
Best regards from Valencia, Spain
Carlos