Help with torque specs.

[99 R/T 10]

Was looking for anybody that can confirm the "upper trans to bellhousing" torque specs. I do have a service manual and I just don't see them. Any help for the community? I just finished the clutch and put the tranny to the bellhousing and it is these bolts I'm not sure of. TIA,

 

[FE 065]

My 2002 manual says:


trans to eng bolts (3/8"), 30 ft.lbs


trans to eng bolts (7/16"), 50ft.lbs


Is that what you need?

 

[99 R/T 10]

Nope, that is the bellhousing to engine bolts. I have those, easy to confirm because the top 4 bolts at 3/8" and the bottom 2 are 7/16". I need the trans to that same bellhousing.

 

[FE 065]

Ok, well... under (transmission) installation it says:


Install upper and lower transmission bolts, tighten to 30 ft lbs


Howzat?

 

[99 R/T 10]

I didn't see that in my book, thanks. I need to go back and put 5 more pounds on those darn things.