jack stands for a 04 srt 10 viper Where???

[Canyon707]

I need to know if I jack my viper up from the jack points where do I put the jack stands or is there another place to jack from and set the jack stands on the rear jack points. I need to remove both rear wheels to work on installing my rollbar and the first step is to remove the wheels and go from there... any help????

 

[twinturbo3150]

I used the frame as the jacking point, then slid the jack stands into the jack points. The frame is stiff that when I jacked up the passenger side the driver's side lifted as well.

 

[Canyon707]

I just got it up in the air finally after fretting.... What I did to start was jack up the driver rear jack point and the whole side came up so I moved to the front driver jack point and did the same thing the driver rear lifted as welland I put a jack stand at the lifting point. I did have to use the frame near the axle to lift the passenger side but it worked out great. Its up and ready for my project. I am also going to install 6 point harness and insulate the floor for heat and sound at the same time. I am going to make templates for this part but, I think with the 3"corsa exhuast, rt 3" cats, floor insulation a rollbar and it shoud be a nice addition to my only girlfriend better than implants..... Well maybe.....
thanks for your help
Chris