Dear Mrs,
I´m from A Mattheis Motorsport and I trying to install a Motec software in our new Viper CC GT3 that we bought from Dodge.
After I install the software on my PC and connected with the car, the dash only works when de ignitions is turned off.
When I turn on the ignition, the communication stop immediatly and only flash ADL2 4.42 in the dash.
So, I think that I loss the right Motec config that came from Dodge.
I can configure the dash perfectly, but only with ignition turned off.
I´m almost right that is a RS232 com problem.
Note: it´s all right before I connect to the car.
How can I solve this problem?
Could anybody send the original dash config arquive for us?
Thank you for your attention.
I´m from A Mattheis Motorsport and I trying to install a Motec software in our new Viper CC GT3 that we bought from Dodge.
After I install the software on my PC and connected with the car, the dash only works when de ignitions is turned off.
When I turn on the ignition, the communication stop immediatly and only flash ADL2 4.42 in the dash.
So, I think that I loss the right Motec config that came from Dodge.
I can configure the dash perfectly, but only with ignition turned off.
I´m almost right that is a RS232 com problem.
Note: it´s all right before I connect to the car.
How can I solve this problem?
Could anybody send the original dash config arquive for us?
Thank you for your attention.