Outer eyebolts for TeamTech install

[Janni]

Jon,
Yours would be the first one that was different, then. We've done 6 or so and I know that TeamTech as shipped hundreds of sets with the same eyebolts for all the holes. Hmmm.... Are you sure that the threads are not just tweaked? Have you tried measuring the bolts themselves instead of the "fit" test? Please let me know.

 

[Jerry Scott[CO]]

Jon
Make this simple test. Place the two bolts, which you think are different, side-by-side so that the threads touch each other and the high points of one go into the low points of the other. If the two engage for the full length of the thread, then the threads are the same. If the outside diameters are the same,(measure them with a caliper), then one should replace the other in the threaded hole.
Jerry Scott