Well I pulled the pas side sill off, been meaning to do that anyway to adjust the Borla length and realign it. But I just see an O2 sensor with wires that seem to be fine. I think I could have accessed the sensor without removing the side sill.
So anyway I’m going to do the driver side tomorrow, same issue with the Borla needing adjustment and retightening. I’m assuming I’m going to find a nice O2 sensor there too. My Yellow shift light does come on - in 1st gear only and randomly, so I’m assuming it’s not a fuse. Can you folks tell me what this solenoid is, where it is located, and should I replace it? I was getting a weird CEL code for a drivers O2 sensor randomly, but it kept clearing itself after 2-3 short drives and I haven’t seen it for months. This one though seems to be real.