Just finished top end job and my "engine light" is on not the check engine light. Had it scanned at a Mopar dealer no error codes were found. I got the fault code using the key on-off-on.... method to get the code, it comes up with error code 12 which in the 94 factory manual does not exist...
hello all
Just getting ready to install complete set of Roe SS brake lines on my 94. The factory set is quit different with mounting support compared to the new ones. Had a few converastion and everyone has a different idea ! At the end of the day i would think they need to be supported...
Currenly I only have the sports bar.On the back of it there are grooves, i thought the shoulder bolt were threaded into the car and would lower the sports bar over this. Hoping there would be enough press on them so it would not blow off at 100MPh....
I have not seen any good pic's to see...
Gentlemen
Got my Gen 1 heads off to update the head gaskets, in the process of getting the heads sent out to make sure they are flat check the valve guides/seat and change out the seals and so one.
Here where I'm at, 94 with 10k miles..Ordered all the typical gaskets...Changing all...
Jon, I'm new to the forum,I have been watching some of Tire threads with Gen 1 with 03 10 spoke wheels but no one has mentioned the driving issues. Is this a big concern for average Hobby driver ???
As i just bought of 08 rims.. for my Gen 1
Hello all,
After a little review, i have noted that my factory seat belts are mounted on the opposite side of the car ? All the Pic in the factory service manual shows the retractor mounted to the door panel. My viper has the belts mounted near the center consol and you have to engage toward...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.