Going to replace my stock radio. The service manual says to remove the dash but
I thought I read a post that said you just had to remove the panel for shifter and radio cover. Has anyone done this and is there anything to watch for. Thanks
Just installed 3" Roe Racing mufflers & Cats a few weeks ago. Fired car up for about 20 minutes at idle a couple of times , I was wondering how long it takes to get the smell of the oil on system to stop. I can't take it out on the road yet, insurance doesn't come on until April 1( PA.) Is...
I'm thinking about installing ROE 3" cats and 3" racing mufflers on my 94 viper. Does anyone have this setup on their Gen.1. How loud is it and hows the
sound. Thanks.
Redoing my exhaust system on my 94 viper. I was wondering what is the largest
diameter muffler and cat that will fit on a gen 1. Has anyone put larger then stock and if any problems. I'd like to use the orginal heat shields if I can.
Thanks
Burped my 94 today and was watching it idle to see if the fan came on. It took awhile for it to come on. It comes on when the needle almost touchs the yellow
on the temp. gage and takes it to 190 and shuts off back on at the yellow. Is that normal and can you adjust when it comes on. I have 180...
Anyone taking their cars to the mopar nationals at norwalk the weekend of Sept. 15-17. If so where is everyone staying, sure would like to park with other vipers. :2tu:
Two question can you run with only the fog lights, Mine do not seem to come on until headlights are on.
Second question while trying to figure out the above, my fog lights quit working after working toggle switch for fog lights. Checked the fuse #2 was ok
switched it out any ways, no luck. Is...
Need some help finding what make of hard top I have on my
1994 viper. I can not see any ID. any where. The sports bar
is removed to put the top on, which might eliminate some.
Any help with identifing marks on others let me know. Thanks.
Made hard launch and fuse panel bracket came off. Are these spot welded on or
glued? Hard to get to place, trying some industrial velcro to see if it'll hold panel in place. Has anyone else had this problem and how did they correct it.
This is on a 94 viper.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.