KNG SNKE
Enthusiast
Ok so I paid my local powder coater to coat a set of valve covers to me. Told him not to chemical dip them, least he got that right.
These valve covers had the DLM stamped in them so my buddy and I filled it in with JB weld and sanded it (recommendation from the powder coater). I go to pick up my valve covers and guess what I see, DLM. These idiots sand blasted it out and just keep going on with business as if it was done right. Beyond that there is a lot of bubbling and bumps all throughout the covers. I have to say I am highly disapointed and I am hoping R&J Distributing will accept these covers as a trade since I am sure their job is of higher quality. I paid 78 dollars for this to get done, guy gave me a discount because he felt bad that he muffed up on the DLM part. Hopefully I can get him to fully sand blast them again and just send them to R&J.
I had to rant, now I'm done.
These valve covers had the DLM stamped in them so my buddy and I filled it in with JB weld and sanded it (recommendation from the powder coater). I go to pick up my valve covers and guess what I see, DLM. These idiots sand blasted it out and just keep going on with business as if it was done right. Beyond that there is a lot of bubbling and bumps all throughout the covers. I have to say I am highly disapointed and I am hoping R&J Distributing will accept these covers as a trade since I am sure their job is of higher quality. I paid 78 dollars for this to get done, guy gave me a discount because he felt bad that he muffed up on the DLM part. Hopefully I can get him to fully sand blast them again and just send them to R&J.
I had to rant, now I'm done.