Recent content by Red94Roadster

  1. R

    Best Dealer with Viper Tech

    Sam,Thanks, ill let you know. What kind of lift do you have? I've thought about buying one myself.Bill
  2. R

    Best Dealer with Viper Tech

    Any other good options? I went to the Spring Tech Day at VanDyke Dodge a few years ago, but haven't heard much about them. I live in Royal Oak, so Dick Scott Dodge is a bit of a hike. Looking to have some fluid changes done on my 2006 SRT-10 and unfortunately don't have the time to do them...
  3. R

    Rear Ended! Help!

    So my worst nightmare happened last Friday at the Woodward Dream Cruise in MI...some a$$hole with happy feet drove into me when the red-light turned green. The damage is two very fine lines in the rear facia paint. They appear to either be stress fractures in the paint/plastic facia, or...
  4. R

    Help with Valve cover replacement

    Any locktite required on the sheet metal screws? Didn't seem like there was any one them when removed.
  5. R

    Help with Valve cover replacement

    I'm replacing the valve covers on my 94, since the paint is chipping off. What is the proper technique for removing the baffles and reinstalling them onto the new covers? I've removed one of the valve covers and there is a baffle with a black liquid gasket around 80% of the perimeter. What...
  6. R

    MCVO Local Discounts

    Is there a list of local VCA vendors offering discounts? Specifically dealers? I need to purchase a service manual for my 2006 and remember a few dealers in the area offering discounts a few years ago. I don't have a list anymore? Thanks
  7. R

    Valve Covers

    I'd like to repair the peeling paint on my valve covers (Gen 1). I've searched the forum and concluded that the factory red wrinkle paint is non-existent. That said, I would like to keep the look as close to stock as possible. I found a set of wrinkle finish, powder coated covers on eBay...
  8. R

    Where to buy OEM leather/vinyl for a black interior?

    Welcome to Detroit Body Products - Supplying Textiles World Wide Try this place...they have been purchasing surplus automotive fabric/leather for years...This is where you go for service parts.
  9. R

    Jack Stand Locations (SRT-10)

    I'd like to change the oil in my newly acquired SRT-10 in my garage. I started jacking up the rear passenger side yesterday, but did not see an obvious place to place a jack stand under the frame so that I could use the hydraulic jack to raise the rest of the vehicle. Is there a good spot or...
  10. R

    Inflator and repair kit

    Can someone post a picture of the factory tire inflator and repair kit from the 2008-newer vipers? I changed the tires on my 2006 from run-craps to PS2s and need to purchase an inflator. Trying to decide whether to purchase factory or get some off the shelf stuff. Thanks
  11. R

    Remove dash for ipod install

    I just purchased an 06 SRT-10 and have not yet had a chance to pick up the service manual. Can someone list the steps to remove the dash, in order to get behind the radio...I don't want to miss a screw or clip and break something. There are the obvious screws on the dash, but ti seems that...
  12. R

    2006 OEM 5 spoke wheels polished Aluminum or Chrome?

    Did stock wheels on a 2006 come from the factory as polished aluminum or chrome?
  13. R

    Blew 1 Pilot Sport tire...what to do next?

    I'm an idiot...didn't see the wheel/tire forum. :doh2: I did read another post and get the general feeling that ppl don't like the ZP tires. So...my question still stands: What do the newer Vipers have instead of a spare? For those who go the Jon B route for tires...who do you have mount...
  14. R

    Blew 1 Pilot Sport tire...what to do next?

    I recently picked up a 2006 SRT-10 w/ 1800 miles. Unfortunately, I ran over a chard of metal tonight and blew the right rear tire. The tires are original Pilot Sport ZP and have great tread on them. Here is my dilemma: It's been my understanding that tires only last about 5 years, so these...
  15. R

    Shopping for Gen 3 SRT-10

    I'm thinking about selling my 1994 RT/10 to upgrade to a Gen 3 SRT-10 and have a question. Are there any differences between the early model years? Mainly 2003, 2004, and 2005? Is there any reason to shy away from a 2003 due to the fact that it's the first year of a new model? I know for...
See more

Latest posts

Members online

Total: 568 (members: 6, guests: 562)

Forum statistics

Threads
153,190
Posts
1,681,849
Members
17,685
Latest member
Lennatave

Share this page

Top